Manual

22
ELECTRONICS
REGULATORY APPROVAL RN4871
!
United States
Contains transmitter module - FCC ID: A8TBM71S2
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
!
Canada
Contains transmitter module - IC: 12246A-BM71S2
This device complies with Industry Canada’s license exempt RSS. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
!
Europe
Compliance testing for transmitter module
CERTIFICATION STANDARDS ARTICLE LABORATORY REPORT NUMBER
Safety
EN60950-1:2006/A11:2009/
A1:2010/
A12:2011/A2:2013
(3.1(a))
TUV
Rheinland
10053210 001
Health EN 62479:2010 10053433 001
EMC
EN 301 489-1 V1.9.2
(3.1(b)) 10052964 001
EN 301 489-17 V2.2.1
Radio EN 300 328 V1.9.1 (3.2) 10053433 001
Notied Body
Opinion
10048936 001