Manual

FIG-1
F
B
C
D
1/16
1/16
5/64
1/16
1/16
5/64
A
E
-
+
+
-
+
+
+
-
-
+
-
-
16
INTRODUCTION
TRIGGER ADJUSTMENT
FIG-1
The rake adjustment screw
A
controls the angle adjustment of the
trigger shoe. Turning the screw counter-clockwise loosens the shoe for
manual angle adjustment. Clockwise locks the shoe back in place.
The spring return screw
B
controls the spring strength of the trigger
return. Clockwise increases the strength, counter-clockwise decreases it.
The post-travel screw
C
adjusts the distance the trigger travels once
pulled. Clockwise reduces the amount of travel (shortening the trigger),
counter-clockwise increases the trigger pull distance.
The pre-travel screw
D
adjusts the distance the trigger travels before
being pulled. Clockwise reduces the amount of travel (shortening the
trigger), counter-clockwise increases the trigger pull distance.
The magnet adjuster screw
E
adjusts the strength of the trigger return.
Clockwise increases the strength, counter-clockwise reduces it.
The trigger retaining screw
F
holds the trigger assembly in place.
Remove the screw and the complete assembly can be removed through
the trigger guard.
WARNING!
Do not wind the screws in too far as this may prevent the CS2 from ring or even
damage the marker. If the pre-travel screw is wound in too far this could cause
the CS2 to re unintentionally.
WARNING