Manual

FIG-1
1
B
1/8
A
-
+
15
INTRODUCTION
VELOCITY ADJUSTMENT
FIG-1
The CS2 velocity adjustment screw is accessed from the underside of
the POPS bonnet.
With the POPS bonnet in the rear (engaged) position, insert a 1/8
hex key
A
into the velocity adjuster screw
B
to adjust the velocity.
1
Turn the hex key clockwise to reduce velocity.
2
Turn the hex key counter-clockwise to increase velocity.
3
Fire two clearing shots after each velocity adjustment for an
accurate velocity reading.
1
DO NOT turn the adjustment screw in too far. This will prevent
the CS2 from ring.
WARNING!
DO NOT exceed 300FPS.
Always wear correct protective equipment when ring your marker.
NEVER leave the CS2 gassed up when unloading.
NEVER point your marker in the direction of other people when not on the eld.
WARNING