User Manual

EAGLE
15
PRINTING & ASSEMBLING MANUAL
© PLANEPRINT
PROFILE P3_SURFACE Light-Weight LW-PLA
The following parts must be sliced with the PROFILE P3_SURFACE (1-wall-print).
Please note the additional settings for the individual parts!
PLEASE NOTE In profile P3_SURFACE, there should not be more than one STL on the buildplate at the same
time, otherwise slicing errors can occur! Depending on your printer, a brim may not be required.
eagle-Wing7_LW-left/right-profile3.stl
MATERIAL LW-PLA, ~ 37 g*
ADDITIONAL SETTINGS
- Setting Profile3_Surface
- Flow 60 %
- Higher nozzle temperature
The optimal weight and sufficient strength is achieved
with 60 % flow. Increase the temperature until the wall
thickness is 0.4 to 0.5 mm. (We print at 250° and 60% flow).
*Display in Cura. The actual weight is then 60% of this.
eagle-Wing8_LW-left/right-profile3.stl
MATERIAL LW-PLA, ~ 30 g*
ADDITIONAL SETTINGS
- Setting Profile3_Surface
- Flow 60 %
- Higher nozzle temperature
LW PLA
Since stringing is unfortunately unavoidable when
printing LW-PLA, this part have to be cleaned up
with the cutter.