User Manual

17
Planar UltraRes X Series User Manual
020-1396-01A
Page | 17
8.2 Other Things You May Need
• LCD screen cleaner or LCD wipes – available at most electronics stores
• At least two very strong people to help lift unit into place
8.3 Plan Your Installation
You should have a detailed plan of how the units are to be configured. The plan should include
calculations for the following:
• Power maximums reference below by display size:
Model
Max Current @ 115VAC
Max Current @ 230VAC
URX75
3.9A
1.7A
URX85
4.9A
2.2A
URX100
5.9A
2.5A
• Cable runs
• Ventilation and cooling requirements
• If hanging display on a wall, location of studs in the wall
• For touch model best performance, the display must be mounted in a vertical to slightly
tilted back orientation.
• If the display is a touch model, it is important that the touch frame is not used to lift or
support the display or touch performance may be compromised. Displays tilted forward
can cause touch beam interference from the glass bowing slightly away from the display
and into the IR path (URX75-ERO-T, URX85-ERO-T and URX100-ERO-T models only).
8.4 Prepare Your Installation Location
• Prepare the area where you will install the unit. If custom enclosures are part of the
installation, they must be fully designed to accommodate the installation of the displays,
the installed units, and ventilation and cooling requirements.
• If your installation includes a lot of construction or dust, it is highly recommended that
you clean all of the screens after the wall installation and configuration are complete.
8.5 Cable Length Recommendations
Cable length performance may vary between different cables and sources. The recommended
maximum cable lengths are as follows:
HDMI
• 4K @ 50/60Hz: 5m (15 ft) maximum
• 4K @ 24/25/30Hz: 15m (50 ft) maximum
• 1080p @ 60Hz and lower resolutions: 20m (65 ft) maximum
DisplayPort
• DP 1.2: 3m (10 ft) maximum
• DP 1.1: 5m (15 ft) maximum