Manual
Table Of Contents
- Contents
- Introduction
- Unpacking and Checking Accessories
- Installing the Displays
- Operating the Display
- OSD Keypad
- Remote Control Receiver
- LED Indicators
- Using the Display in Portrait Mode
- Using the Display in Flat or Tilted Orientation
- Using the Remote Control
- IR Command Protocol
- Turning the Display On
- Turning the Display Off
- Adjusting the Volume
- Selecting Layouts and Input Sources
- Navigating Through the Menus
- Using the Touch Screen
- Touchscreen MultiTouch Driver Installation
- Touchscreen (PQLabs) MultiTouch Platform Content
- Uninstalling the MultiTouch Driver
- Planar UltraRes Remote Monitoring Software
- External Control
- Signal Compatibility
- Color Subsampling Support
- Specifications
- Dimensions
- Troubleshooting During Installation
- Accessing Planar’s Technical Support Website
- Index
Remote Monitoring System Settings
76 Planar UltraRes Series User Manual
The options under Notification Events are:
• Power On/Off: Occurs when standby mode is entered and when the display is
powered on.
• System Error: Occurs when the display has detected an error within the
system.
• Source Detect: Occurs when the display detects and displays a new input
signal.
• Source Lost: Occurs when the current input signal is no longer detected.
• Source Selected: Occurs when a different input source is selected for any of the
zones.
Note: Each event can be sent to one or more recipients. To add multiple email addresses,
separate them by a space.
• Test Email: Sends a test of the selected email notification. This is useful for
verifying that your email account settings are setup correctly. If the test email
fails, you can use the View Last 10 Log Messages button to get more detailed
information about the failure.
Remote Monitoring System Settings
This page enables you to make adjustments to a variety of system settings.
For the OSD equivalent, refer to "System Settings Submenu" on page 63.