user manual
LT3200OwnerManual
11|Page
4- Locate the video connector in cable
assembly as shown in photo 4 at right.
5- Orient the video plug as seen
in Photo 5A. Insert the edge into
its socket on the video board.
Align the connector parallel to the
socket and gently slide the
connector into the socket (Photo
5B). Using steady pressure
between thumb and fingernail of
index finger, seat the connector.
A properly inserted connector will
have the backside of the connector located parallel
to the socket. The white arrows (Photo 5C) point
out the slots in the socket that should be fully filled
with the white color of the connector.
6- Place the video ground clasp around the bare-metal
section of the video cable and attach it to the standoff
near the LED connector on the LED driver board. See
photo 6 at right.