user manual
Table Of Contents
- Table of Contents
- Introduction
- Installing a Planar UltraRes Display
- LCD Installation
- Installing the UltraRes Control Software
- Using the UltraRes Control Software
- UltraRes Dimensions
- Display Dimensions - Front and Side Views
- Display Dimensions - Rear View
- Landscape Wall Mounts - Front View
- Landscape Wall Mounts - Sides Views
- Portrait Wall Mounts - Front View
- Portrait Wall Mounts - Sides Views
- Optional Pedestal Mount - Front View
- Optional Pedestal Mount - Top and Bottom Views
- Optional Pedestal Mount - Single and Double Sided
- Planar UltraRes Remote Monitoring Software
- RS232 Communication
- RS232 Commands
- Command Format
- Response Format
- Supported UltraRes 4K Commands
- Specifications
- Troubleshooting During Installation
- Accessing Planar’s Technical Support Website
- Regulatory Information
- Index
Planar UltraRes Remote Monitoring Software
Planar UltraRes User Manual 67
Network Setup
This page allows you to configure network settings and whether or not you use
DHCP.
1 In the Hostname box it now says Planar. Change this name to something more
appropriate. This will be the name for this particular server. The hostname is
limited to 16 characters: alphanumeric, dash, or underscore only.
2 If you want to enter a domain name for server name lookups, type it in the
Domain name box.
3 Do one of the following:
• If you will use DHCP, go to step
4.
• If you will not use DHCP, go to step 5.
4 Under the DHCP section, choose Yes, u se D HC P.
a Change the default DHCP timeout (ten seconds) only if instructed by your
network administrator.