Systems Computer Accessories User Manual

Connecting Power
m70L Installation & Configuration Guide 19
Connecting Power
The display typically draws 6.5A at 115V or 3.25A at 230V. For countries outside of
North America, it is the responsibility of the installer to provide the power supply
cord certified for use in the destination country.
Connect a power cable to the power supply and to an AC source. The power supply is
auto-ranging, so it works with any source from 100 to 240 VAC, 50 to 60 Hz.
Note: Not for connection to two-phase systems. For connection to single-phase supplies
only.
The AC Master switch is next to the power receptacle, both of which are located in
the rear of the display.
About UPS Supplies
Some installations use a UPS - Uninterruptible Power Supply. Most UPS devices will
work with the m70L. Review the power specifications of your UPS device to make
sure it is compatible with the m70L.
Power receptacle and power switch location