Systems Computer Accessories User Manual

Installation Checklist
m70L Installation & Configuration Guide 11
Installation Checklist
Use this quick checklist to ensure you have performed the installation steps in the
correct order.
1 Unpack the display and check the contents see "Unpacking and Checking
Accessories" on page 11.
2 Install power and source cables:
• See "Connecting Source Cables" on page 17.
• See "Connecting Power" on page 19.
Unpacking and Checking Accessories
Accessories With Each m70L Display
Quick Start Guide, Installation & Configuration Guide
The Quick Start Guide provides the basic setup needed to get the m70L up and
running. It does not contain the detailed information included in this Installation &
Configuration Guide.
Remote Control
The batteries are already installed.
Power Cord
For use in North America.
VGA Cable
15-pin cable for analog computer pictures
(although this is called a VGA cable, it carries
anything up to UXGA).
Note: Although VGA and DVI cables are included with every unit, you may wish to obtain a
long-run VGA or DVI cable if your source is located far away from the display(s).
Rip-Ties
These are included if you want to bundle cables. They can be
attached to the chassis or to a mount.