Systems Flat Panel Television User Manual

Advanced Options
m40L/m46L Installation & Configuration Guide 61
Auto Setup Options
Auto Setup Options set what will happen automatically and what will not.
To access the AUTO SETUP OPTIONS menu, press MISC five times on the remote.
Each of the checkboxes in Auto Setup Options can be turned on or off by selecting it
(using the up/down arrows) and pressing ENTER.
Retry on Lost Signal
Occurs only when the present signal (picture) disappears or changes in some way. If
this item is not checked, the display will not try to sync to a new signal. Keep this
menu item checked.
Note: Searching will not happen just because the picture goes black. Black, from video or
from a computer, is a valid picture. The signal itself (the sync pulses) must be lost to trigger a
search.
“Do” Checkboxes
Each DO that is checked will adjust the display, one process at a time, until all the
processes are completed.
In the following situations, each of the checked
DO boxes will be done in the order
shown in the menu:
• If a new signal is acquired, either through selecting a different connector or
because the source picture has changed modes, such as from WXGA to UXGA.
• When you press the SETUP button on the remote.
Do Frequency and Do Phase
Works separately to find the frequency and phase of the computer picture and
adjusts to them. This works best on a picture that has a lot of sharp changes in
brightness, such as text (adjacent white and black pixels).
Auto Setup Options
Retry on Lost Signal
Do Frequency
Do Phase
Do Position