Systems Flat Panel Television User Manual
Table Of Contents
- Table of Contents
- Safety for You and the m40L/m46L
- Recommended Usage
- VESA Mounts, General Description
- Before You Begin
- Installation Checklist
- Unpacking and Checking Accessories
- Connecting Source Cables
- Connecting Power
- Connecting RS232 Communication
- Connecting RS232 Cables
- Using the Remote
- Selecting the Source
- Automatically Selecting the Source
- Manually Selecting the Source
- Adjusting Input Levels
- Adjusting Frequency and Phase
- Aspect Ratio Settings
- Adjusting Sharpness
- Adjusting Position
- Tiling a Display
- Zoom and Viewport
- Adjusting Color Balance
- Advanced Options
- Backlight Control
- Serial Port Settings and Diagnostics
- Saving and Recalling Configurations
- Checking Unit Status
- Where to Go From Here
- Downloading Additional Documentation and Firmware
- Downloading Utility Software
- m40L Dimensions
- m46L Dimensions
- Index
Adjusting Sharpness
m40L/m46L Installation & Configuration Guide 41
Adjusting Sharpness
After you set the Scale Mode to the one you will use for the program, select the
Sharpness level in the PICTURE menu to reduce scaling artifacts. If you are not scaling
your image, you may skip this section.
Sharpness Settings
The Sharpness setting is in the PICTURE menu (press FREQ/PHASE
on the remote).
Sharpness settings determine how crisp the image should be. There are sixteen
levels of sharpness, where 0 is the softest and 15 is the sharpest. Seven is the default.
Make any adjustments to sharpness with the picture scaled, that is, with the Scale
Mode set the way you will use it. Use Sharpness to reduce artifacts of scaling.
Note: The Sharpness adjustments are in effect only when the image is scaled.
For instructions on how to set Scale Mode, see "Scale Mode Settings" on page 35.
Picture
Source S-Video
Video Standard NTSC 60 Hz/3.58 MHz
Vertical Frequency (frame locked) 60Hz
Sharpness 4
Input Levels