Systems Flat Panel Television User Manual
Table Of Contents
- Table of Contents
- Safety for You and the m40L/m46L
- Recommended Usage
- VESA Mounts, General Description
- Before You Begin
- Installation Checklist
- Unpacking and Checking Accessories
- Connecting Source Cables
- Connecting Power
- Connecting RS232 Communication
- Connecting RS232 Cables
- Using the Remote
- Selecting the Source
- Automatically Selecting the Source
- Manually Selecting the Source
- Adjusting Input Levels
- Adjusting Frequency and Phase
- Aspect Ratio Settings
- Adjusting Sharpness
- Adjusting Position
- Tiling a Display
- Zoom and Viewport
- Adjusting Color Balance
- Advanced Options
- Backlight Control
- Serial Port Settings and Diagnostics
- Saving and Recalling Configurations
- Checking Unit Status
- Where to Go From Here
- Downloading Additional Documentation and Firmware
- Downloading Utility Software
- m40L Dimensions
- m46L Dimensions
- Index
Aspect Ratio Settings
m40L/m46L Installation & Configuration Guide 39
Justify Settings
Justify determines how the picture will be placed in a wall of displays. For a single
display, Justify determines placement on the screen.
Top/Left
Positions the image starting with the top, leftmost display, then across and down. If
the image is not large enough to fill all the displays, they are left blank.
Center
Positions the image starting with the center of the image in the center of the wall
spreading out equally to all displays. If the image is not large enough to fill all
displays, they are left blank.
Bottom/Right
Positions the image starting with the bottom, rightmost display, then across and up.
If the image is not large enough to fill all the displays, they are left blank.
Overscan
This is used to hide blank areas and stray lines in the edges of an image. The lower
the overscan setting, the more of the optical image that is seen. Standard CRT
televisions have an overscan of about 5%. Overscan defaults to 3% for video images.