Systems Flat Panel Television User Manual
Table Of Contents
- Table of Contents
- Safety for You and the m40L/m46L
- Recommended Usage
- VESA Mounts, General Description
- Before You Begin
- Installation Checklist
- Unpacking and Checking Accessories
- Connecting Source Cables
- Connecting Power
- Connecting RS232 Communication
- Connecting RS232 Cables
- Using the Remote
- Selecting the Source
- Automatically Selecting the Source
- Manually Selecting the Source
- Adjusting Input Levels
- Adjusting Frequency and Phase
- Aspect Ratio Settings
- Adjusting Sharpness
- Adjusting Position
- Tiling a Display
- Zoom and Viewport
- Adjusting Color Balance
- Advanced Options
- Backlight Control
- Serial Port Settings and Diagnostics
- Saving and Recalling Configurations
- Checking Unit Status
- Where to Go From Here
- Downloading Additional Documentation and Firmware
- Downloading Utility Software
- m40L Dimensions
- m46L Dimensions
- Index
Automatically Selecting the Source
26 m40L/m46L Installation & Configuration Guide
• Composite
• Component (YPbPr)
• SDI
Note: For additional information about source selection, see "Preferred Source Detection" on
page 60.
Picture
Source Comp Video
Video Standard NTSC 60 Hz/3.58 MHz
Vertical Frequency (frame locked) 60Hz
Sharpness
Input Levels
Picture
Source Component (YPbPr)
Video Standard NTSC 60 Hz/3.58 MHz
Vertical Frequency (frame locked) 60Hz
Horizontal Frequency 50.00kHz
Horizontal Resolution 1366
Vertical Resolution 768
Frequency
1602
Phase
22.5°
Sharpness 4
Input Levels
Picture
Source SDI
Vertical Frequency (frame locked) 60Hz
Horizontal Frequency 50.00kHz
Horizontal Resolution 1366
Vertical Resolution 768
Sharpness 4