Systems Flat Panel Television User Manual
Table Of Contents
- Table of Contents
- Safety for You and the m40L/m46L
- Recommended Usage
- VESA Mounts, General Description
- Before You Begin
- Installation Checklist
- Unpacking and Checking Accessories
- Connecting Source Cables
- Connecting Power
- Connecting RS232 Communication
- Connecting RS232 Cables
- Using the Remote
- Selecting the Source
- Automatically Selecting the Source
- Manually Selecting the Source
- Adjusting Input Levels
- Adjusting Frequency and Phase
- Aspect Ratio Settings
- Adjusting Sharpness
- Adjusting Position
- Tiling a Display
- Zoom and Viewport
- Adjusting Color Balance
- Advanced Options
- Backlight Control
- Serial Port Settings and Diagnostics
- Saving and Recalling Configurations
- Checking Unit Status
- Where to Go From Here
- Downloading Additional Documentation and Firmware
- Downloading Utility Software
- m40L Dimensions
- m46L Dimensions
- Index
Automatically Selecting the Source
m40L/m46L Installation & Configuration Guide 23
Automatically Selecting the Source
1 Aim the remote control at the screen and press SOURCE.
a The display looks at each of the connectors and stops on the first one that is
receiving a valid picture.
b If this is successful (it may take 10 seconds) stop here.
c If you have several sources connected, press SOURCE again to go to the next
one with a picture.
d If you get no picture or have other trouble, see "Manually Selecting the
Source" on page 23.
Manually Selecting the Source
1 After the display is on, press FREQ/PHASE on the remote. This opens the PICTURE
menu.
2 Using the up/down arrows, select the SOURCE line and press ENTER.
Picture
Source Analog
Sync Type Separate H&V
Vertical Frequency (frame locked) 60Hz
Horizontal Frequency 50.00kHz
Pixel Frequency 80.10MHz
Mode ID: 31 HPer: 3178 VLines: 525
Horizontal Resolution 1366
Vertical Resolution 768
Frequency
1602
Phase
22.5°
Sharpness
Input Levels