Systems Flat Panel Television User Manual
Table Of Contents
- Table of Contents
- Safety for You and the m40L/m46L
- Recommended Usage
- VESA Mounts, General Description
- Before You Begin
- Installation Checklist
- Unpacking and Checking Accessories
- Connecting Source Cables
- Connecting Power
- Connecting RS232 Communication
- Connecting RS232 Cables
- Using the Remote
- Selecting the Source
- Automatically Selecting the Source
- Manually Selecting the Source
- Adjusting Input Levels
- Adjusting Frequency and Phase
- Aspect Ratio Settings
- Adjusting Sharpness
- Adjusting Position
- Tiling a Display
- Zoom and Viewport
- Adjusting Color Balance
- Advanced Options
- Backlight Control
- Serial Port Settings and Diagnostics
- Saving and Recalling Configurations
- Checking Unit Status
- Where to Go From Here
- Downloading Additional Documentation and Firmware
- Downloading Utility Software
- m40L Dimensions
- m46L Dimensions
- Index
Connecting Power
m40L/m46L Installation & Configuration Guide 15
Connecting Power
The m40L can draw up to 2.0A at 100V or 1.0A at 200V. The m46L can draw up to 2.6A
at 100V or 1.3A at 200V. For countries outside of North America, it is the responsibility
of the installer to provide the power supply cord certified for use in the destination
country.
Connect a power cable to the power supply and to an AC source. The power supply is
auto-ranging, so it works with any source from 100 to 240 VAC, 50 to 60 Hz.
The AC Master switch is next to the power receptacle, both of which are located in
the rear of the display.
About UPS Supplies
Some installations use a UPS - Uninterruptible Power Supply. Most UPS devices will
work with the m40L/m46L. Review the power specifications of your UPS device to
make sure it is compatible with the m40L/m46L.
Power receptacle and power switch location