Systems Flat Panel Television User Manual
Table Of Contents
- Table of Contents
- Safety for You and the m40L/m46L
- Recommended Usage
- VESA Mounts, General Description
- Before You Begin
- Installation Checklist
- Unpacking and Checking Accessories
- Connecting Source Cables
- Connecting Power
- Connecting RS232 Communication
- Connecting RS232 Cables
- Using the Remote
- Selecting the Source
- Automatically Selecting the Source
- Manually Selecting the Source
- Adjusting Input Levels
- Adjusting Frequency and Phase
- Aspect Ratio Settings
- Adjusting Sharpness
- Adjusting Position
- Tiling a Display
- Zoom and Viewport
- Adjusting Color Balance
- Advanced Options
- Backlight Control
- Serial Port Settings and Diagnostics
- Saving and Recalling Configurations
- Checking Unit Status
- Where to Go From Here
- Downloading Additional Documentation and Firmware
- Downloading Utility Software
- m40L Dimensions
- m46L Dimensions
- Index
Installation Checklist
m40L/m46L Installation & Configuration Guide 11
Installation Checklist
Use this quick checklist to ensure you have performed the installation steps in the
correct order.
1 Unpack the display and check the contents see "Unpacking and Checking
Accessories" on page 11.
2 Install power and source cables:
• See "Connecting Source Cables" on page 13.
• See "Connecting Power" on page 15.
Unpacking and Checking Accessories
Accessories With Each m40L/m46L Display
Quick Start Guide
The Quick Start Guide provides the basic setup needed to get the m40L/m46L up
and running. It does not contain the detailed information included in this Installation
& Configuration Guide.
Remote Control
The batteries are already installed.
Power Cord
For use in North America.
VGA Cable
15-pin cable for analog computer pictures
(although this is called a VGA cable, it carries
anything up to UXGA).
DVI-D Cable
For use with the monitor.
Note: Although VGA and DVI cables are included with every unit, you may wish to obtain a
long-run VGA or DVI cable if your source is located far away from the display(s).