Systems Flat Panel Television User Manual
Table Of Contents
- Table of Contents
- Safety for You and the m40L/m46L
- Recommended Usage
- VESA Mounts, General Description
- Before You Begin
- Installation Checklist
- Unpacking and Checking Accessories
- Connecting Source Cables
- Connecting Power
- Connecting RS232 Communication
- Connecting RS232 Cables
- Using the Remote
- Selecting the Source
- Automatically Selecting the Source
- Manually Selecting the Source
- Adjusting Input Levels
- Adjusting Frequency and Phase
- Aspect Ratio Settings
- Adjusting Sharpness
- Adjusting Position
- Tiling a Display
- Zoom and Viewport
- Adjusting Color Balance
- Advanced Options
- Backlight Control
- Serial Port Settings and Diagnostics
- Saving and Recalling Configurations
- Checking Unit Status
- Where to Go From Here
- Downloading Additional Documentation and Firmware
- Downloading Utility Software
- m40L Dimensions
- m46L Dimensions
- Index
m40L/m46L Installation & Configuration Guide 9
Installing an
m40L/m46L
This section explains how to install an m40L/m46L. We suggest that you read the
entire section before you attempt to install the unit.
Before You Begin
Make sure you have all the items in these checklists before you begin unpacking and
installing your m40L/m46L(s).
Plan Your Installation
You should have a detailed plan of how the units are to be configured. The plan
should include calculations for the following:
• Power (maximum of three units per 20A circuit for 115V operation)
• Cable runs
• Ventilation and cooling requirements
• If hanging display on a wall, location of studs in the wall
Prepare Your Installation Location
You should have prepared the area where you will install the unit. If custom
enclosures are part of the installation they must be fully designed to accommodate
the installed unit and ventilation and cooling requirements.
Tools and Other Things You May Need
• Tools:
• Level to ensure the display is hung straight
• Stud finder (if hanging display on a wall)
• Computer network LAN cables (straight through - no crossover) to interconnect
multiple displays for RS232 control
• LCD screen cleaner or LCD wipes, available at most electronics stores
• At least two people to help lift units into place