Systems Flat Panel Television User Manual
Table Of Contents
- Table of Contents
- Safety for You and the m40L/m46L
- Recommended Usage
- VESA Mounts, General Description
- Before You Begin
- Installation Checklist
- Unpacking and Checking Accessories
- Connecting Source Cables
- Connecting Power
- Connecting RS232 Communication
- Connecting RS232 Cables
- Using the Remote
- Selecting the Source
- Automatically Selecting the Source
- Manually Selecting the Source
- Adjusting Input Levels
- Adjusting Frequency and Phase
- Aspect Ratio Settings
- Adjusting Sharpness
- Adjusting Position
- Tiling a Display
- Zoom and Viewport
- Adjusting Color Balance
- Advanced Options
- Backlight Control
- Serial Port Settings and Diagnostics
- Saving and Recalling Configurations
- Checking Unit Status
- Where to Go From Here
- Downloading Additional Documentation and Firmware
- Downloading Utility Software
- m40L Dimensions
- m46L Dimensions
- Index
Checking Unit Status
m40L/m46L Installation & Configuration Guide 91
Checking Unit Status
1 Press MONITOR on the remote.
Backlight Status Shows
• OK if both banks of backlights are functioning normally
• FAILED if the backlight banks are not functioning normally
Internal Temperature
Indicates the current internal temperature at one point inside the unit. This is not the
highest nor the lowest temperature of the unit, nor an indicator of ambient
temperatures.
Unit Status
m40L 1366 x 768
010-0781 Rev 00
Asset Tag:
Mode ID: 123 HPer: 3178 VLines: 525
Curtain or Test Pattern is displayed
Backlight Status OK
Internal Temperature: 32ºC