Systems User's Guide Monitor Dome E4c

Display Installation | 7
Setting the display mode
1 Right-click the desktop and select Properties > Settings.
2 Select the monitor that you want to change. Then click Advanced.
3 Click the Monitor tab. Make sure that the check box for Hide modes
that this monitor cannot display is empty (unchecked).
4 Click the Adapter tab, then click the List All Modes button.
5 Choose the mode and click OK.
6Click Apply or OK.
Display information is read via the DDC interface between the
graphics board and the display interface board. The video board
driver configures timing parameters using the EDID of the display.
Any rotation support is provided by the display controller, which also
provides lookup table support for gamma correction.
Setting brightness
You must have the Dome CXtra software installed to change the
display brightness. Adjust the value of the white level on the
Backlight tab of the RightLight Panel Configuration.
Removing the driver
1 Close all applications that are running.
2 Navigate to the Control Panel. Select Add/Remove Programs.
3 Select your current graphics card drivers. Select Add/Remove.
Follow the wizard to remove your current display drivers.
4 Restart your system.
ex.book Page 7 Friday, January 13, 2006 1:04 PM