Systems User's Guide Monitor Dome E4c

4 | Dome E4c Display
Display Installation
Before you install the display controller, remove any existing graphics
card and its driver from your computer. After installation, the display
turns on automatically when you turn on your computer system.
Installing the controller and display
1 Remove the computer cover and the blank bracket from
the available PCI Express slot.
2 Insert the display controller into the slot, align the connector pins,
and press the board down until it is firmly seated. Secure the
mounting bracket and reattach the cover.
3Plug the DC power cord into the power input port on the display.
Connect the dual-link DVI cable to the display.
4 Connect the DVI cable to the display controller installed in
the computer. Use video port #1. Plug the AC power cord into
the power adapter and into the grounded power outlet.
WARNING
In locations where 240V outlets are used, use the E4c display only on
a center-tapped, 240V, single-phase supply.
Turn off your computer before you install the board, but leave
the power cord plugged into the grounded outlet. Otherwise, you
could get an electric shock and cause damage to the components.
To prevent electrostatic discharge, take these precautions:
• Remove the controller slowly from its static-shielding bag.
• Wear an antistatic wrist strap.
• Repeatedly touch the power supply or the metal surface of
the computer chassis to discharge your body’s static electricity.