Systems User's Guide Monitor Dome E4c

About the Display | 3
The ports for connecting the power cord and the video cable are on
the back. The power input port is an 8-pin DIN connector that drives
power to the display. The power input is 24V ±5% (115 W typical).
See detail below for pin assignment.
The dual-link DVI connector drives the data to the display. When the
DVI cable is disconnected, the display backlight turns off and the unit
enters power-saving mode.
Display brightness and power saving functions are controlled via the
Dome CXtra software. No other user-accessible controls are available.
Pin assignment of DIN connector
8-pin connector on
Dome E4c display
DIN connector, left
Dual-link DVI connector, right
VCC 7
VCC 8
1 GND
VCC 5 3 GND
2 GND
VCC 6
4 GND
ex.book Page 3 Friday, January 13, 2006 1:04 PM