User manual

33.. EExxtteerrnnaall DDiimmmmiinngg CCoonnnneeccttoorr

Connector type: Molex Micro Fit 3.0

Mating connector: Molex 43025-0600 (housing) and Molex

43030 (terminals)

EExxtteerrnnaall DDiimmmmiinngg CCoonnnneeccttoorr PPiinn CCoonnffiigguurraattiioonn aanndd DDeessccrriippttiioonn

Pin Name Description

1 Ground Electrical ground

2 Reserved For factory use only, leave unconnected

3 DIM_Input 0-5V analog input for external dimming, connect to wiper of

dimming pot if used

4 /Ext_DIM, Input to determine brightness control mode; has 10k pull up to +5V

Logic high (or unconnected) = Automatic Brightness Control mode

Logic low = Manual Brightness Control mode

5 Ground Electrical ground; connect to lower leg of dimming potentiometer

if used

6 Vref +5V reference voltage output with 470 ohm series resistance;

connect to upper leg of dimming potentiometer if used

44.. CCoooolliinngg KKiitt PPoowweerr OOuuttppuutt CCoonnnneeccttoorr

Note: There is no need to connect to this connector. Information is shown for reference only. If a

Cooling Kit option is ordered, the required cooling kit power cable will be installed at the factory.

OOppttiioonnaall CCoooolliinngg KKiitt PPiinn CCoonnffiigguurraattiioonn

Pin Description

1 Switched Return

2 +12V output

MMoouunnttiinngg

M4 threaded holes are provided in the sides of the monitor housing for mounting purposes. The

blind holes will accommodate 10 mm long screws. See the mechanical outline drawing 076-0579-00

at www.planar.com/support for details.