Installation guide

RS232 Commands
Planar UltraLux Series Installation Guide 33
28 Set Mute to "off" 08 22 0A 00 00 00 00 CC deactivates Mute
29 Get Mute 04 21 14 C7 If Mute has been changed by
OSD commands, returns "Mute =
value" where 0 is mute off and 1
is mute on; may not reflect
actual Mute settings if Mute
settings were changed by serial
commands (known bug)
30 Get Input Status 04 21 07 D4 returns "HDMI", "VGA", or "DPRx"
(if no source is present, returns
the last source searched…so use
the Get Power Status command
to check for active source)
31 Set Color Space to full
color
08 22 12 00 00 00 00 C4 color space set to full color
32 Set Color space to SRGB 08 22 13 00 00 00 02 C1 color space set to sRGB
33 Get Color Space 04 21 15 C6 returns "Color Space = value"
34 Do an Auto Adjust 08 22 07 00 00 00 00 CF if VGA (analog) source is present,
a sync/timing auto adjust is
done
35 Do Auto Color Adjust 08 22 08 00 00 00 00 CE if VGA source is present, a gray
level auto adjust is done
36 Do a Reset 08 22 11 00 00 00 00 C5 restores all settings to their
factory defaults
37 Get Blacklevel
Brightness
04 21 17 C4 returns "Brightness = value",
where value ranges from -350 to
350 (this scale is different from
the 0-255 scale used in the OSD)
38
Set Blacklevel
Brightness
Set to 50: 08 22 16 00 00
00 32 8E
sets the offset for the color range
to allow adjustment of the
definition of black (See HDMI
Full Range commands)
39 Get Auto Scan Status 04 21 18 C3 returns "Auto Scan = value",
where value is 1 (on) or 0 (off)
40 Set Auto Scan to "on" 08 22 17 00 00 00 01 BE Sets Auto Scan on, where the
source inputs will continually be
checked for activity beginning
with the default or selected
source