User's Manual

Operating the Display
Page | 32
EP Series Ultra HD LCD Displays User Guide
020-1350-01D
16.4 Turning the Display Off
With the power on, press the power button on the remote or side control panel to put the LCD
panel in a standby mode. To turn off power completely, turn the AC switch to “O” or disconnect
the AC power cord from the power outlet.
Note: If there is no signal for a certain period of time, the LCD panel will automatically go into
standby mode.
16.5 Adjusting the Volume
1. Using the remote, press the VOLUME - or VOLUME + to increase or decrease the volume.
2. Press the MUTE button to temporarily turn off all sound. To restore the sound, press the
MUTE button again.
Note: The analog audio out is variable. S/PDIF is fixed.
16.6 Selecting the Input Source
Do one of the following:
• Using the remote, press the desired source button (DP1, DP2, HDMI1, HDMI2, HDMI3,
HDMI4, OPS, VGA).
• Press the source button on the display’s keypad. Use the arrow buttons () to select
one of the following input sources and press ENTER: DP1, DP2, HDMI1, HDMI2, HDMI3,
HDMI4, OPS, VGA).
Note: When the display cannot find a source, a “No signal” message will appear.
16.7 Navigating Through the Menus
1. With the power on, press MENU. The INPUT menu appears.
2. Within the menu, use , , , , and ENTER to navigate through the menus and
adjust options.
3. Press MENU to return to the previous menu. To exit the menu system, press EXIT.