NAMES OF PARTS: # FRONT Tracer arm ‘Tracing magnifier BACK Integrating wheel Encoder Ni-Cd battery EXPLANATION OF DISPLAY SYMBOLS Symbols are displayed as follows: SCALE: Appears when setting a scale value offer than 1:1. HOLD : Appears when key is pressed during measurement. MEMO : Appears to indicate a measured value stored in memory. Bat-E « Appears when battery charge becomes necessary. Km®* acre Hr + Only one of the selected units is displayed.
EXPLANATION OF FUNCTION KEYS : Power ON key : Power OFF kay : Numerical key + Decimal point key : Start measurement HOLD : Temporarily put measurement on hold : Ending measurement and memory ETHEREAL ER AVER : Calculate average value UNIT + Unit system selection key [onto | + Unit selection key within each unt system SCALE : Scale setting key Not applicable to this model : Clear key (10 erase memory and measured values) POWER SUPPLY This instrument supports both AC and BC power supply methods.
CHAPTER 1 TAKING MEASUREMENT 1-2 DONUTS PATTERN 1-1 NORMAL PATTERN first starting point second starting point starting point . Pu ta mark at a paint on the circumference of the drawing to be measured. This point will be the starting point of the measurement. Put another point on the internal circumference. This 1. Put a mark at a point on the circumference of the drawing to be measured. point will be the starting point for the internal circumference measurement.
6. Set the center of the tracer lens to match the internal circumference starting point as shown in the figure. Press key. The HOLD condition is released and "HOLD? disappears from display. 7. Keeping the tracer point of the tracer lens onto the internal circumference line, trace anticlockwise. 1-3 TWO DRAWINGS ARE SEPARATED 8, After going round, press | MEMO | yoy Measurement stops. A buzzer sounds, “MEMO” is displayed and the measured value is displayed.
Set the center of the tracer lens to match the starting point on the second drawing as shown in the figure. = o . Press HOLD | key. Measurement restarts “HOLD” disappears from display. ™ Keeping the tracer point of the tracer lens onto the circumference CHAPTER 2 SELECTION OF UNITS Units can be selected from the Metric system (cm, m, km} or English system {in, ft, acre) or the Japanese unit system (3%, FZ, BT} 1.
+ If due 16 sangs in unit system, the calculated value goes over and above) or under and below). The display will show as in the figure on the right. NOTE Using Auto power off, or even if the Key is pressed fo tum power off, units are stored in memory. Therefore, until new values are set, it is possible to continue usage as iris. On this instrument, calculation is based on 1 foot = 12 Inches. If you wish fo lake measurements in ha (hectares), first measure in km? and then divide by 100.
CAUTION « If the scale changes, measured values are re-calculated and displayed accordingly. (Example) If scale is 1:1 (A=1, B=1}, measured value is as shown on the figure to the right. 1f scale Is changed to 50:1 {A=50, B=50), measured value will change as shown on this figure. «if due to change In scale, the calculated value goes over (39993699 and above) or under and below). The display will show as in the figure on the right.
Press START | key 10 take the third measurement. Press |_ MEMO | key to finish the third measurement, 4. Pressing the LEAVER | key will display the average value. Stored memory will be cleared. CAUTION The memory can store 10 measurements data.
QUICK MANUAL 1. MEASUREMENT Press | START | to start measurement, trace external circumference, press | MEMO | i finish. 2. AVERAGE VALUE “Take a number of measurements (fess than 10 times), Press | AVER | 3.SET SCALE Press | SCALE | gel the vertical scale. Press SCALE | again to set the horizontal sale. Press | SCALE | again to finish. 4.
