Instructions

36
If the switch is set to recirculation mode (F), the horizontal exhaust
opening (B) will be blocked automatically. The exhaust air can only escape
via the air outlet C (s. above).
2.2 Required tools
Drill, flat head screwdriver, cross head screwdriver, tin snips, 3/8" socket or ratchet
with extension, measuring tape, hand saw or jigsaw, insulating tape, adhesive tape.
WARNING! Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
WARNING! Do not damage the wiring in the wall while drilling
NOTICE! At least one assistant is required for installation.
2.3 Installation on a cupboard
1. Specify the position of the appliance at the cupboard according to the drawing
below. Screw 4 supplied screws into the cupboard relevant to the position of the
4 slots for the screw heads on the appliance. Do not tighten the screws completely
as you have to hang the appliance on the screw heads.
2. Hang the appliance on the screw heads. Insert the screw heads into the round
slots; then move the appliance so that the screw heads are in the narrow section
of the suspension. Tighten the 4 screws to ensure safe and proper positioning.
3. Fix screws through the small safety holes to protect the appliance from
unintended moving.