Instructions

46
Contamination of the control panel.
1. Disconnect the appliance from
the mains (fuse-box).
2. Take away the contamination.
3. Wipe the sensors with a damp
sponge or cloth.
4. Dry the sensors with kitchen
paper.
5. Connect the appliance to the
mains again.
The appliance may beep and
automatically turn off. The sensors
may not work properly when they
are wet. Dry the control panel
carefully before you put it into
operation again.
Do not use any abrasive detergents! Do not use any organic detergents!
2
Do not use essential oils!
6. Trouble shooting
ERROR
CAUSES
MEASURES
The appliance cannot be switched on.
 Break in the power supply.
 Check that the appliance is
connected to the mains. Check the
household fuse box. Is there a power
failure at your place of residence?
The sensors do not respond.
 The sensors are locked.
 Unlock the sensors.
The sensors are difficult to operate.
 Liquid on the sensors.
 You used your fingertip.
 Dry the sensors.
 Use the bottom of your top phalanx.
The glass ceramic is scratched.
 You used unsuitable cookware with
sharp edges.
 You used an unsuitable detergent,
e.g. an abrasive.
 Use suitable cookware.
 Use suitable detergents.
Some cookware make cracking or clicking noise.
 Your cookware is produced with
layers made of different kinds of
metal.
 This is normal for such a cookware
and does not indicate a malfunction.
The appliance makes humming noise when used on a high heat setting.
 Caused by induction-cooking.
 Normal operating condition, but the
2
Detergents such as vinegar, citric acid etc.