Instruction Manual

~ 144 ~
Always observe the instructions in chapter 6.2 STARTING OF A CLEANING
PROGRAMME.
4. Press the « EXTRA DRYING » - BUTTON (« ») once to activate the programme
function « EXTRA DRYING » for the set cleaning programme.
5. The operational status indicator of this function goes on.
6. The programme function « EXTRA DRYING » is activated.
7. Press the « START / STOP » - BUTTON to start the set cleaning programme.
If the selected cleaning programme cannot be combined with the desired
programme function(s), these functions cannot be selected or will be cancelled
and the indicators switches off automatically.
PROGRAMME FUNCTION: « HALF LOAD »
❖ The programme function « HALF LOAD » can be set for some cleaning
programmes.
❖ Select this programme function if you want to clean max. five place settings or
less. If you put more than six place settings in the appliance and still select this
programme function, the cleaning effect of the appliance may be reduced.
❖ The energy and water consumption of a cleaning programme may be reduced by
this programme function.
NOTICE! Do not use this programme function when the dishwasher is
fully loaded, otherwise the cleaning effect of the appliance will be
reduced.
The programme function « HALF LOAD » may not be available for all cleaning
programmes (see also chapter 6.1 THE ADDITIONAL PROGRAMME FUNCTIONS).
HOW TO ACTIVATE THE PROGRAMME FUNCTION
« HALF LOAD »
1. Switch on the appliance using the « ON / OFF » - BUTTON.
2. The appliance is now in STANDBY MODE.
3. Set the desired cleaning programme using the « PROGRAMME » - BUTTON. Use the
corresponding buttons to set the desired additional programme functions.
Always observe the instructions in chapter 6.2 STARTING OF A CLEANING
PROGRAMME.
4. Press the « HALF LOAD » - BUTTON (« ») once to activate the programme
function « HALF LOAD » for the set cleaning programme.
5. The operational status indicator of this function goes on.