Instructions

70
6.1 Starting of a programme
1. Fill the lower rack first.
2. Pour the dishwasher detergent and the water softener (=dishwasher salt) in the
relevant containers.
3. During operation the appliance must be supplied with water ( full water
pressure).
4. Close the door and press the On/Off button.
5. Press the PROGRAMME button to select a programme. The sequence is:
Intensive→Ecos→90 Min.→Quick
6. When you have selected a programme, the relevant indicator goes on. Then
press the Start/Pause button to start the appliance.
6.2 How to change a running programme
You can only change a programme when it has run a short period of time.
Otherwise the detergent has dissolved and the dishwater has been
drained. In such a case you must refill the detergent container.
1. Press and hold the Start/Pause button longer than 3 seconds. The appliance
changes to stand-by mode; now you can re-programme the appliance.
When you open the door while the appliance is operating, the appliance will stop
operating. The display indicates 8:88 (flashing). An acoustic signal sounds once per
minute. When you close the door again, the appliance will start operating after 10
seconds.
6.3 Subsequent addition of dishes
You can put dishes later in the appliance unless the detergent container has opened.
1. Press the Start/Pause button.
2. Open the door slightly to stop operation.
3. You can open the door completely after the rotating spray arms stopped
operation.
4. Now you can add dishes.