Instructions

53
2.3 Installation steps
1. Install the front panel (E) on the exterior side of the door using the supplied
brackets. Use the template for proper position of the brackets (fig. 1)
2. Set the tension of the door springs using an Allen key. Rotate the right and left
door spring in clockwise direction (fig. 2). Failure to do this could cause damage
to your appliance
3. Connect the water supply hose to the cold water supply ( see chapter COLD
WATER CONNECTION).
4. Connect the water drain hose (see chapter CONNECTION OF THE DRAIN HOSE).
5. Connect the power cord. (see chapter POWER CONNECTION).
6. Fix the condensation strip (F) under the work top (fig. 3). The condensation
strip should fit flush to the edge of the worktop.
7. Place the appliance into position (Abb. 4)
8. Level the appliance. The back feet can be adjusted from the front by rotating
the screw in the centre of the housing; use an Allen key (fig. 5/A). Use a flat
screwdriver to adjust the front feet (fig 5/B).
9. The appliance must be secured in place. There are two ways to do this:
a. Wooden worktop: Fix it on the worktop using the wood screws. Please check,
that the door does not touch the worktop when being opened (fig. 6).
b. Worktops made of marble or granite: Install the bracket on the side of the
appliance. Fix the appliance on the kitchen furniture. Cover the screw using the
rubber cap (fig. 7)