Instructions
29
7. Install the fixing bracket on the corresponding position on the wall.
8. Fix the upper chimney using 4*10 screws on the fixing bracket.
9. Insert the grease filters and connect the appliance to the mains
3
.
➢ Check the correct position of the hood from front and side perspective.
Otherwise the appliance will not work properly.
2.3 Disassembling of the appliance
NOTICE! Two assistants are required for the disassembling of the
appliance.
1. WARNING! Unplug the appliance or disconnect it from the mains
(use the relevant fuse in your household fuse box).
2. Remove the grease filter(s). Remove the carbon filter(s) if installed.
3. Observe the following steps a-d.
3
If the socket is covered by the chimney, you must plug in the appliance at an
earlier point in time.