Instructions

31
2. Tilt the appliance slightly backwards and secure it in this position to get access to
the bottom hinges.
3. Remove the two screws (1) which clamp the bottom hinge on the door casing.
Unscrew the adjustable foot (3). Remove the left adjustable foot (4) and install it
on the opposite (right) side.
4. Open the door a bit and remove it from the bottom hinge. Remove the spring
(5) from the opening on the top right side and the pin (6) on the top right side of
the door.
5. Remove the anchor cap (7) from the top left door opening and insert it firmly in
the opening of the top right side.
6. Insert the pin (6) in the opening on the top left side of the door. Then insert the
spring (5) in the relevant opening on the top left side.
7. Replace the door. Check that the pin (6) matches the relevant opening on the
bottom side of the upper doorway.
8. Fix the bottom hinge (2) with the door closed and tighten the screws (1).
9. Fix the worktop (9) and part 8. Tighten the screws (10). Reinstall the covers (11).
Adjust the door properly.
The seals must close properly.
Electrical connection
WARNING!
Do not use a socket board or a multi socket or an extension cord when using
220–240 V/50 Hz alternate current (AC).All electrical connections which may be
damaged must be repaired by a qualified professional.
All repairs should be performed by your authorized after sales service.
1. An electrical supply of 220-240V AC / 50 Hz is required.
2. Connect the appliance to a suitable and dedicated socket only.