Instructions

28
5. Connect the suspension device with 8 screws type M4*10 to the angle irons (fig.
2).
6. Calculate the needed length of the angle irons. Fix the angle irons with 16 big
flathead screws type M4*10 and M4 nuts. An overlapping length of at least 100
mm is required.
7. Insert the extension tube into the 170 mm-hole and lead it outwards(fig. 3).
8. Fix the inside chimney with 4 screws type ST4*8 on the suspension device.
Push the outside chimney on the inside chimney. Use the S-hook to hold the
chimney while installing it.
9. Fix the chimney with 4 screws type ST4*8.
10. You need at least two persons to lift the hood. Fix the hood with 16 screws type
M4*10 on the angle irons.
11. Now pull the extension tube and fix it. Ensure that there are not any gaps.
Remove the S-hook and pull the outside chimney to its proper position.