User's Manual

wrangler
wrangler User Manual V.7.072022
Page 7
SMART CHARGING SYSTEM
wrangler Operational Safety Guidelines
This equipment is not suitable for outdoor use. Use only in dry locations and conditions.
Maximum ambient temperature around the charger must not exceed 40°C (104 °F).
walt can be on or o while charging.
Connect the charger only to the approved power cord listed.
Make sure the power cord is located where it will not be stepped on, tripped over, or subjected to
water, damage or stress.
Connect the power cord only to an appropriately fused and wired AC outlet with the correct
voltage as specified on the product. The power supply block has a green indicator light on it.
Disconnect from line voltage by removing the power cord from the AC outlet.
The equipment shall be connected to a nearby and easily accessible socket outlet.
All standard safety precautions regarding the operation of electrical devices must be followed.
In no circumstance should the charging of walt or using the wrangler mass charging unit be done in
a way that would exceed the electrical circuit and circuit breaking safety mechanisms.
Using wrangler
wrangler is specifically designed as a mass charging cradle for walt. Each unit is designed to
charge up to five walt at any given time. Follow the simple steps for setting up and using wrangler.
1. Take wrangler out of the box and set it up in a clean and dry indoor
environment.
2. Plug the
power cord
(ref. 2) into the
power supply block
(ref. 3).
3.
Plug the power supply block cord (ref. 3) into wrangler (wrangler is now set up and ready
to charge 1 or 5 walt Smart Radios at a time). Each mass charging craddle pocket is
equipped with a tag that once the walt is set in the charging craddle, it will identify
its charging location within the wrangler.