Installation Guide

PENDANT MOUNTING INSTRUCTIONS GUIDE (Continued)

7. Locate the mounting tabs on the back of the ﬁ xture and bend tabs upward

to the desired position. Using cable B, clip each small hook to one tab of the

ﬁ xture.

Attach ﬁ xture to ceiling using the cable A

Note: It is recommended for two people to attach ﬁ xture to the ceiling.

8. Place the level on ﬁ xture to conﬁ rm ﬁ xture is leveled and at even length on both ends

If ﬁ xture is not level or desired height needs to be adjusted, ﬁ nal adjustments can be made by

either feeding the cable wire through the metal insert or releasing the wire from the metal insert

(as described in step #7) to achieve desired height and levelness. Once desired height and

levelness is accomplished, cut any excess feed wire for a clean ﬁ nish.

Note: It is recommended to use two people when making ﬁ nal adjustments while ﬁ xture is hung.

9. With the junction box bracket and screws, mechanically secure the bracket with the provided screws to

the junction box.

WARNING - Risk of ﬁ re or electric shock. Disconnect and turn power o at fuse or circuit breaker before

any installation in the junction box.

10. At the desired length, route and feed the wire cord through the junction box cover plate and secure the wire cord to the

cover plate using the cover plate wire plug.

Note: A minimum of 3 additional inches wire cord length will be required for wiring connection to the junction box branch

circuit supply wires.

11. Using the wire nuts provided, connect the “hot” wire of the branch circuit supply to the black wire from the wire cord.

Connect the “neutral” wire of the branch circuit supply to the white wire from the wire cord. Connect the ground wire of the

branch circuit supply to the Green wire from the wire cord.

12. Insert the all electrical wiring connections into the junction box and secure the junction box cover plate to

the junction box bracket using the provided cover plate screw.

13. Re-connect power to the circuit at the main fuse or circuit breaker.

WARNING - Do not place or store items on top of ﬁ xture.

6. Take one ceiling cable (A) to insert and feed into the metal insert on the

ﬁ xture cable (B) as shown in photo. Feed cable A with large hook until

desired length is reached. Length can be adjusted by pressing down on the

tip of the metal insert while simultaneously pulling back on the cable wire.

Apply the same procedure to the second set of cable A and B.

If you have any questions, problems or missing parts, please contact customer

service by phone at 888-925-7494 or by email support@pixi-lighting.com

TWO YEAR LIMITED WARRANTY

Cable A

Cable B