Operation Manual

Press left move button[ ]or right move button[ ]will
move the functional icon to the channel icon[ ]. Press
Setting/Enter button to change the channel, you will see
the channel number is flashing.
Thought pressing increment button[ ]or decrement
button[ ] to adjust the channel number.
4. Press Setting/Enter button again to save the present channel.
1 3
1 2
Turned on/off the power
Channel setting
Channel setting for transmitter(TW-282TX)
Preparation for installation and usePreparation for installation and use
The transmitter(TW-282TX)
Press any button once, and turn on the power of transmitter.
The transmitter stays in the single shooting mode when you
turn on the power; timing plan and channel setting will not
be changed.
Th e di sp la y sh ow s th e si n gl e sh oo ti ng ico n an d
communication channel.
The transmitter without any operation (except timing plan or
implementing BULB status) will shut down automatically
after one minute.
The receiver(TW-282RX)
1. Hold the power button for 2sec to turn on the POWER
Green LED light will be flash every 2sec and the screen
displays communication channel.
2. After turn on the power, the set timing communication
channel remain effectively.
3. The receiver does not turn off automatically. In the power-
on state, press power button 2s and the receiver will be
turned off.
[ ]
Channel setting for receiver(TW-282RX)
Turn on the power; the channel is default as the last time
setting.
Press [+CH] and [CH-] button enter to channel setting,
the channel icon [CH] on the screen will be flashing.
[+CH] is increase the numbe, [CH-] is reduces the number.
ress [+CH] and [CH-] button at same time, or no-action for
10 second, can save and exit.
P
2s
* The channel of transmitter and receiver should be the same for shooting effectively.
1.
2.
3.
4.
1.
2.
3.
1.
2.
3.
4.