Operation Manual

1. Press left move button[ ]or right move button[ ],
move the transmitter’s activities icon to the icon of timing
shots [ ].
2 7
2 6
Shooting control
Shooting control
The shot number setting
2. Press the setting button enter to set the number of photo
in timing plan's, Press [ ] to increase the photo number;
Press [ ] to reduce the photo number. 1-99photo number
is available, when the screen display means this is
unlimited to take the photo.
[ -- ]
3. By pressing button[ ]or[ ],enter into the
setting for “ exposure time” and “ delay time” ,
“interval time” as the shown picture.
Press
Press
Press
Press
Interval
time
of
timing
plan
setting
Delay
time
of
timing
plan
setting
4. Press the set button, save and exit settings.
Search the timing plan
1. Press left move button[ ]or right move button[ ],move transmitter’s activities
icon to timing plan icon which can check the related timing project.
2. When check the related projects, if need adjust the parameters, only press the
set button to enter the relevant project settings, press the set button again to exit
and save your setting. Move the icons sequence showed as below.
Press
Press
Press
Press
Press
Press
Press
Press
Press
Press
Delay
shoot
-ing
function
Singl e
shoot
-ing
func tion
Execute timing plan
1. Press the left move button[ ]or right move button[ ],
move the activities icon to any icon among the timing plan
shooting area.
Delay time Exposure time Interval time
Number of photo
2. Press the timer plan start/stop button transmitter
sends the information to receiver. The green light of receiver
will be flash twice every 2 sec; that' s mean the receiver is
[ ];
completely to receive information and start operate correctly. Timing plan will be
working in the receiver and send the control signal to the camera.