Operation Manual

2 3
2 2
Shooting control
Shooting control
4. When countdown is completed, will follow the setting shots output a
signal per second to control shooting.
receiver
When the camera function is set to be [ ], the camera will perform one or more delay
shooting.
When the camera lens focus function is set to be [ M ],the camera will not execute focusing
action if half-press the release button of the transmitter.
Make sure to set the camera function to be [ ].
When the camera function is set to be [ ], it will start continuous shooting.
[ ], It will be shooting every sec if camera is set as BULB it may cause the problem of under
or over exposure.
When the camera lens focus function is set to be [ AF ], even receiving the shooting signal
the camera will not shoot at the moment as most of camera don't seize focus.
3. By pressing button[ ]or[ ],enter into the setting for minutes and hours , as
the sketch map.
“ ” “ ”
Timing plan for shooting
Delay time setting
1. In the power-on state, move the functional activities icon to
the delay timing program icon[ ]by pressing the left move
button[ ]or right move button[ ].
2. Press the set button, enter the delay time for ‘second bit’
setting.
Press
Press
Press
Press
Press
Press
Press
Press
The
shot
number
of
timing
plan
setting
Exposu
-re
time
of
timing
plan
setting
Delay time of timing
plan--hours setting
Delay time of timing
plan--minutes setting
Delay time of timing
plan--seconds setting
Gently press button[ ]once to set numerical increased, hold it on, set the value rapidly
increased; Press the button[ ]once to set the numerical reduced, hold on to set the
values rapidly reduced.
4. Press the set button, save and exit settings.
5、 Before delay time planning completed, press either transmitter button or
receiver button or other , will terminate this planning.