Operation Manual

1 9

1 8

Shooting control

2. Half-press the release button and transmitter will send

signal for focusing, the green indicator will lit on the

transmitter and receiver, and the camera is in the focusing

state until the release or full-press the button.

3. Full-press the release button, red indicators of the

transmitter and receiver will be lit, keep fully press the button,

the transmitter will send signal of shooting continuously, the

indicators will blink red and green light in turn. The camera

will start to shot, and the shooting speed will be one photo per

sec.

4. Release the release button, the transmitter stop sending signal for shooting and

the camera will stop shooting.

Make sure to set the camera function to be [ ].

When the camera function is set to be [ ], it may cause continuous shooting.

[ ], It will be shooting every sec if camera is set as BULB it may cause the problem of under

or over exposure.

When the camera function is set to be[ ], the camera will execute delay shooting.

shooting

1. In the power-on state, move the transmitter's activities

icon to shooting icon[ ] by pressing the left move button

[ ]or right move button[ ].

2.Half-press the release button and transmitter will send

signal for focusing, the green indicator will lit on the

transmitter and receiver, and the camera is in the focusing

state until the release or full-press the button.

3.Full-press the release button, transmitter will send

signal. The red indicator of transmitter starts flashing and start

timing, the indicator of receiver will keep lighting. The transmitter continuous

output shooting signal. Camera enters into exposure shooting continuously.

BULB

4. Press the release button again, the transmitter stop sending out the

shooting signal and the time also stopped on screen displays.

BULB

Make sure to set the camera function to be [ ].

When the camera function is set to be [ ], the camera only shoot once but not BULB

shooting.

When the camera function is set to be [ ],the camera will be continuous shooting.

When the camera function is set to be [ ], the camera will be delay shooting once.