Operation Manual

1 7

1 6

Shooting control

Sketch map for selecting function mode:

shooting functionSingle shooting function

Press

Continuous shooting

within one sec function

Delay shooting function

The instruction is under the premise that the receiver and camera have been

connected tightly, and turned on the power of camera and receiver. The detail

instruction of remote shooting will be showing as follow.

Single shooting

1. In the power-on state, set the single shooting icon [ ] by pressing the

move button[ ]or right move button[ ].

left

In the sleeping state, press any key to wake up transmitter to enter single shooting mode.

2. Half-press the release button and transmitter will send signal for focusing, the

green indicator will lit on the transmitter and receiver, and the camera is in the

focusing state until the release or full-press the button.

3. Full-press the release button and transmitter will send

signal of shooting. The red indicator will light for a while, the

camera start shooting.

Make sure to set the camera function to be [ ].

When the camera function is set to be[ ], it may cause continuous

shooting.

[ ],

When the camera function is set to be [ ], the camera will execute

delay shooting.

It will be shooting every sec if camera is set as BULB it may cause

the problem of under or over exposure.

Continuous shooting within one sec

1. In the power-on state, move the transmitter’s activities icon to continuous shooting

within one sec icon[ ] by pressing the left move button[ ]or right move button[ ].

Continuous shooting within one sec second is patent function which issued by

Pixel limited Enterprise, it'll support spacing continuous shooting within one sec and

never change the single shooting mode.

the firs

Shooting control