Operation Manual

1 5
1 4
The differences between[ ]mode and[ ]mode are as follow: [ ]function is the release
button is pressed fully and keep on, shoot every second and stop shooting until the release
button is released. While[ ] function is the camera will start shooting when the release
button is pressed fully until press it again, the shooting will stop.
Make sure to set the camera function to be [ ].
When the camera function is set to be [ ], the camera only shoot once but not[ ]
shooting.
When the camera function is set to be [ ],the camera will be continuous shooting.
When the camera function is set to be [ ], the camera will be delay shooting once.
Delay shooting
Delay shooting setting
1. In the power-on state, move the activities icon to delay
shooting icon[ ] by pressing the move button[ ]or
right move button[ ]. Press the set button entering the
left
delay setting for adjusts the shooting numbers. Then the
numbers of shooting icon [ ],number of shooting [ ]will
blink at the same time.
2. Press button[ ]settings shot number can be increased,
press button [ ], settings shot number can be reduced. It
can be set between 1 to 99 sheets .
3. Press button[ ]enter into the delay setting of delay
shooting. The delay shooting time icon[ ], delay shooting
time[ ]will blink at the same time.
4. Press the button[ ], set the delay time increased,
press button[ ], set the delay time reduced. It can be set
between 1 to 59 seconds.
5. After set up the new parameters, press the set button, save and exit settings.
When enter to the delay shooting set, timer remote control will save the previous setting.
By pressing the left button[ ]or right button[ ], convert shooting numbers and delay
time settings.
Gently press button[ ]once to set numerical increased, hold it on, set the value rapidly
increased; Press the button[ ]once to set the numerical reduced, hold on to set the
values rapidly reduced.
The delay shooting function of TC-252 can user-defined the delay time and shots.
Shooting control Shooting control