Operation Manual

1 3
1 2
one second icon[ ]as the function one by pressing the move button[ ]or
right move button[ ].
left
2. Half-press the release button, the green light lit, and
the camera is in the focusing state until release or full-press
the button.
4. Release the release button, the camera will stop
shooting.
Make sure to set the camera function to be [ ].
When the camera function is set to be [ ], it may cause continuous shooting.
When the camera function is set to be [ ],the camera will shoot based on [ ] function,
it may cause underexposure or overexposure.
When the camera function is set to be[ ], the camera will execute delay shooting.
[ ]shooting
1. In the power-on state, move the activities icon to [ ] shooting icon[ ]
by pressing the left move button[ ]or right move button[ ].
2. Half-press the release button, the green light lit, and
the camera is in the focusing state until the release or full-
press the button.
3. Full-press the release button, the red light starts
flashing and start timing, the timer remote control
continuous output shooting signal, the red light keep
flashing. Camera enter into [ ] shooting.
4. Press the release button again, timer remote control
will stop output shooting signals, camera stop [ ] shoot.
Continuous shooting within one second is one patent function which issued by Pixel
limited Enterprise, it' ll support spacing continuous shooting within one second and
never change the single shot mode of the camera.
3. Full-press the release button, red indicator will be light,
keep fully press the button, the indicator will flash red and
green in turn. The shooting speed will be one photo per
second.
Shooting control Shooting control