Operation Manual

1 1

1 0

[ ]shooting function

Single shooting

Sketch map for selecting function mode:

Single shooting function

Press

The instruction is under the premise that the timer remote control and camera

have been connected tightly, and turned on the power of camera and timer

remote control. The detail instruction of remote shooting will be showing as

follow.

Continuous shooting

within one second function

Delay shooting function

1. In the power-on state, set the single shooting icon [ ] as the function

one by pressing the left move button[ ]or right move button[ ].

In the sleeping state, press any key to wake up timer remote control to enter single

shooting mode.

In the sleeping state, it can focus and shot under the single mode without wake up.

2. Half-press the release button, the green light lit, and

the camera is in the focusing state until the release or full-

press the button.

3. Full-press the release button, red light will light for a

while, the camera start shooting.

Make sure to set the camera function to be [ ].

When the camera function is set to be[ ], it may cause continuous

shooting.

When the camera function is set to be[ ],the camera will shoot

based on[ ]mode, it may cause underexposure or overexposure.

When the camera function is set to be [ ], the camera will execute

delay shooting.

Continuous shooting within one second

1. In the power-on state, move the activities icon to continuous shooting within

Part of the cameras can' t support to wake up the external shutter, it' s unable to wake up

the external shutter and take photo when the camera is dormant.

Shooting control Shooting control