Operation Manual

3. By pressing button[ ]or[ ],enter into the setting for minutes and hours ,
“exposure time”, “interval time”,“shots number” as the sketch map.
“ ” “ ”
1 7
1 6
Operate the delay shooting
1. Press the left button[ ]or right button[ ], move the
activity icon to the delay shooting icon[ ].
2. Half-press the release button, the green light lit, and
the camera is in the focusing state until the release or full-
press the button.
3. Full-press the release button, timer remote control
start to delay countdown, red indicator blink quickly and
enter to the delay shooting mode.
4. When countdown is completed, timer remote control
will follow the setting shots output a signal per second to
control shooting.
When running the delay shooting, press the launch button again, the delay shooting
will stop.
Make sure to set the camera function to be [ ].
When the camera function is set to be [ ], it will start continuous shooting.
When the camera function is set to be [ ],the camera will shoot based on [ ] function,
it may cause underexposure or overexposure.
When the camera function is set to be [ ], the camera will perform one or more delay
shooting.
When the camera lens focus function is set to be [ M ],the camera will not execute focusing
action if half-press the release button of the timer remote control.
When the camera lens focus function is set to be [ A ], even receiving the shooting signal
the camera will not shoot at the moment when most of camera don't seize focus.
Timing plan for shooting
Delay time setting
1. In the power-on state, move the functional activities
icon to the delay timing program icon[ ]by pressing the
left move button[ ]or right move button[ ].
2. Press the set button, enter the delay time for ‘second
bit’ setting.
Shooting control Shooting control