Instruction Manual

To learn more on how to operate your specific receiver refer to the SiriusXM Radio user manual that came with the receiver.
Audio Port
Antenna Port Power Port FM Port
Pixel Technologies, Inc. | www.pixelsatradio.com | [e-mail] | [phone] | Page 4
Step 6 - Connecng Docking Cradle
Aer all cables have been run to the protecve case, feed the wires
up through the boom of the case shown in the image on the right.
Pull enough cable through to allow for extra play in the wire in case a
cable is pulled. If there is extra antenna wire, it is recommended to
wrap up the excess antenna wire inside the protecve case.
Next, connect each cable to the corresponding port on the dock.
(Some docks may have the connecons on the sides and not the
back as shown in the figure to the right)
Note: If installing a Bluetooth SiriusXM™ Dock, only power and
antenna are required. The FM port on the dock is not used unless
installing the FMDA25 Direct Wire Audio Adapter.
Aer all connecons have been made, slide the receiver down onto
the dock and power on the unit. If installing a new SiriusXM™
receiver, follow the instrucons on how to acvate the receiver
provided in the receivers user guide.