Instruction Manual

BACK PLATE ASSEMBLY
Locate the bag containing the parts shown below.
Step 2 - Place the parts as pictured below. Take the AMPS Socket Plate and place it on one side of the
L-bracket. Next place the Dual Male AMPS Plate on the opposite side as the AMPS Socket Plate and line up
the screw holes. Please note the posioning of the Dual Male AMPS Plate with the notches at the boom.
The dual notches must be posioned at the boom in order to properly seat into the back of the case.
Use the supplied screws and nuts to secure the plates to the L-bracket. The mount can be assembled with
the top plate of the L-bracket facing forward or backwards to fit your installaon needs. Next, slide the
L-bracket assembly onto the back of the protecve case. The case should slide down over the dual notches.
Oponal - RAM Mount Assembly
To install the kit onto a RAM mount, use the RAM Mount Adapter Plate located in the supplied parts bag.
Screw the RAM Mount Adapter Plate to the L-bracket with the Dual Male AMPS Plate on one side and the
RAM Mount Adapter Plate on the other side. The mount can be assembled with the top plate of the
L-bracket facing forward or backwards to fit your installaon needs. Next, slide the L-bracket assembly onto
the back of the protecve case. The case should slide down over the dual notches.
AMPS Socket Plate with Lock Ring
Dual Male AMPS Plate
Metal L-bracket
RAM Mount Adapter
Pixel Technologies, Inc. | www.pixelsatradio.com | [e-mail] | [phone] | Page 2