Instruction Manual

Pixel Technologies, Inc. | www.pixelsatradio.com | [e-mail] | [phone] | Page 4
Step 3 - Connect Display Controller
Included in the package is a micro USB to micro USB cable that
powers the display controller. Run that cable from the power
adapter to the protecve case. Feed the wire up through the
boom of the case as shown in the figure to the right. The case
has several different sized spacers. Use the spacer that best
mounts the display controller inside the case.
Note: Using all spacers will give you the best results when
pressing buons. The spacers will push the controller to the
front of the case, making it easier to press the buons on the
controller.
Addional Resources
Fully Assembled
When fully assembled, the unit should look like the images below.
Roady BT Quick Start Guide
Roady BT Quick Start Guide