Instruction Manual

Place the parts as pictured below. Take the AMPS Socket Plate and place it on one side of the L-bracket.
Next, place the Dual Male AMPS Plate on the opposite side as the AMPS Socket Plate and line up the screw
holes. Please note the posioning of the Dual Male AMPS Plate with the notches at the boom. The dual
notches must be posioned at the boom in order to properly seat into the back of the case. Use the
supplied screws and nuts to secure the plates to the L-bracket. The mount can be assembled with the top
plate of the L-bracket facing forward or backwards to fit your installaon needs. Next, slide the L-bracket
assembly onto the back of the protecve case. The case should slide down over the dual notches.
Oponal - RAM Mount Assembly
To install the kit onto a RAM mount, use the RAM Mount Adapter Plate located in the supplied parts bag.
Screw the RAM Mount Adapter Plate to the L-bracket with the Dual Male AMPS Plate on one side and the
RAM Mount Adapter Plate on the other side. The mount can be assembled with the top plate of the
L-bracket facing forward or backwards to fit your installaon needs. Next, slide the L-bracket assembly onto
the back of the protecve case. The case should slide down over the dual notches.
RAM Mount Adapter
Pixel Technologies, Inc. | www.pixelsatradio.com | [e-mail] | [phone]
Step 2 - Connect Mount to Back Plate and Mount Antenna
To connect the handlebar or strap mount to the back plate, insert the ball joint into the AMPS Female Socket
Plate with the Lock Ring having the wide end facing towards the socket plate. Push the mount into the socket
unl it clicks. Once the ball joint is firmly in place, screw the Lock Ring clockwise unl it ghtens all the way.
To change the angle of the case, loosen the ring and pivot the case, then reghten the Lock Ring to secure.
Do not over ghten the Lock Ring to avoid damaging it. Next, place the antenna on the metal L-bracket and
run the antenna wire through the boom of the case connecng it to the antenna port on the dock.