Operation Manual

Product Function

Trigger Sync Mode

Coding...

mast er

remove it.

control each other. When group setting is enabled, LCD screen will show the corresponding group. Turn it off to

2、

After coding succeeded, the brightness of the same groups of the corresponding LED lights can freely adjust and

of Group B. Adjustment can be made as long as the group that already opened is the same as any of the group.

Group A. When BC on the same group, if need to adjust the brightness of the lights, subject to the brightness

3、

When ABC, AB on the same group, if need to adjust the brightness of the lights, subject to the brightness of

Sonnon DL-914 is equipped with wired or wireless triggering

Wired Triggering

trigger, just coding without connecting them via cables one by one.

sets witch opened, LED light will be off, at this time, it will enter to trigger status). If multi lights are needed to

then connect 3.5 port to LED light. When triggering, turn on the LED trigger set switch to trigger (when trigger

with PC trigger port (If not, you may purchase the power adapter with PC port), connect PC port to camera, and

When using wired triggering, you only need one Pixel PC-3.5 connecting cable. But your camera must be equipped

Wireless Triggering

the LED lights that will be joined. After coding succeeded, you may use it.

required to purchase separately. When using with King Pro for wireless triggering, please be sure to coding all

When using wireless triggering, it needs to work with Pixel King Pro transmitter. Pixel King Pro transmitter is

not be available, and it will enter to trigger status.

coding.When triggering, you need to turn on the trigger set sync switch of the LED light. Now, the LED light will

the LCD screen of the LED light will be back to the current status. Then restart King Pro transmitter to complete

time, at this time, King Pro LCD screen will show Coding… it means coding is in progress. After coding succeeded,

the LCD screen. And then press the button C on the King PRO transmitter and turn on the power at the same

LED light and turn on the power at the same time. Release the sync switch until BIND RX will be displayed on

1、

When using King Pro transmitter for triggering, the coding steps as: press and hold Group B sync switch of the